2
CHANGING THE TIP
Use the tip removal device Ref. 0114108.
1
Remove the ring to release the tip.
ENGLISH
TIP CARE
- To clean the tips, use the sponge included
with the stand and check it is slightly moisted.
Only deionised water (car battery water)
Only deionised water (car battery water)
Only deionised water (car battery water)
Only deionised water (car battery water)
Only deionised water (car battery water)
should be used in order to wet the sponge
should be used in order to wet the sponge
should be used in order to wet the sponge
should be used in order to wet the sponge
should be used in order to wet the sponge.
If normal water was to be used, it is very
likely that the tip will become dirty due to the
salts dissolved within the water.
- Do not file the tips or use abrasive tools which
may damage the tip’s protective surface
coating and avoid knocking them about.
- If the tip has been a long time without being
tinned, use the metal brush Ref. 0297705
adaptable to the support, to remove any dirt
and oxid.
2
Remove the tip by pulling the soldering iron
lengthwise without forcing the element.
Before fitting the new tip, clean the part of the
element which is covered by the tip, to eliminate
any contamination and facilitate the insertion
of the new tip.
3
Insert the new tip and make sure that it has
penetrated fully home, otherwise its thermic
performance would be altered and would not
correspond to the temperature reading.
JBC reserves the right to after specifications without prior
notice.
