Jayco PINNACLE, Руководство пользователя

Страница: 72 / 187

62
S
LIDEOUT
S
YSTEMS
After the slideout is extended, verify that the corners of the
black rubber seal are set up correctly. The corners of this
seal are cut at a 45° angle. The top of the outside seal must
overlap the side of the seal to avoid the possibility of water
penetration. On the inside seal, the side seal should overlap
the top.
Retracting slideout room
Press the IN section of the slideout control switch and hold
it until the motor stops. Operating the switch after the room is fully retracted will damage
the switch and motor.
Maintenance
Your slideout system has been designed to require very little maintenance. To ensure a long
life of your slideout system, read, understand and follow these simple instructions. This
system contains a pre-lubed bearing that is lubricated when the room is moved in and out.
Do not spray oil or grease on the rails while the room is extended.
Troubleshooting the Slideout
If the slideout does not move when the slideout switch is depressed, follow these steps.
Check the auxiliary battery (customer supplied) for a full charge and good wire
connections.
Check the 12-volt fuse or circuit breaker.
Check for loose connections at the slideout motor.
If the slideout still will not operate, follow these steps.
,IWKHVOLGHRXWLVH[WHQGHGUHIHUWRWKHVHFWLRQRQRSHUDWLQJWKHVSHFL¿FVOLGHRXWV\VWHP
installed on your RV.
If the slideout is retracted, leave it in that position.
Contact your dealer or customer service for repair assistance.Your recreation vehicle
may include one or more of the following slideout systems.
S
LIDEOUT
S
YSTEMS
Schwintek Inwall slideout system
The in-wall slideout system requires no maintenance it will never require any adjustments.
The in-wall system has two vertical columns. Each side has a drive motor located at the top
of the column. The right hand and left hand motors remain synchronized by the dual motor
synchronous velocity slide controller (a circuit board typically located in the basement area
of the recreation vehicle.
Slideout overlap-outside
Do not work on your system unless the 12-volt DC (auxiliary battery, customer
supplied) and 120-volt AC electrical systems (shore line power cord) have
been disconnected.
9#40+0)