Jasic EVO 2.0 EP-45, Руководство оператора

Страница: 19 / 50

19
DESCRIPTION OF ‘ TFT - LCD ’ CONTROL PANEL
Display screen options
Cutting current configuration
Whether you access either continuous or mesh cutting mode the
display window will show the cutting current (as shown right).
By rotating the control dial you will adjust the cutting current
value.
2T/4T function settings
2T and 4T torch trigger (latch) selection is a useful function when carrying out longer cuts.
When cutting in 4T mode you can remove your finger off the torch trigger and the arc will remain on until
you either press the torch trigger again or you remove the plasma arc away from the material being cut.
When in the ‘ Continuous Cut ’ mode, press the control dial to enter the icon options on the left and
scroll to ‘ P ’ and again press the control dial. From here you can select either 2T or 4T.
Please Note: 2T/4T (4T) is not available in grid cutting mode.
Cutting torch length and post - flow time configuration
Whether you are in ‘ continuous ’ or ‘ mesh cutting ’ modes you can
enter the ‘ D ’ tab which takes you into both plasma torch length
selection and post gas time
The first tab highlighted right is the parameter settings that allows
you to select the plasma torch length that is fitted to the machine.
You can select torch lengths as follows:
0, 6M, 10M, 15M and 20M (0, 20, 33, 49 and 66 feet) with 0 being the
auto setting, which measures the resistance of the plasma torch cable
and automatically sets the torch length accordingly to ensure pilot
current and air flow time is accordingly.
The second tab highlighted right is the parameter settings that allows
you to select post gas time. When cutting finishes the air is required to
stay on for a period of time to assist with the cooling the consumables
and torch. Post flow time is adjustable between 10 ~ 60 seconds.
The factory setting is 15 seconds.
2T
4T