www.janitza.de
21
Modules 800-CT8-A | 800-CON
4.2 Mounting the 800-CON module
Observe the mounting instructions of your basic
device (e.g. check bus connector installation!) and
mount the 800-CON module (transfer module) in the
de-energized system as follows:
1. Press in the bottom bolts on the rear of the
module.
INFORMATION
·The following module assembly sequence must
be observed!
·Always mount components of your JanBus sys-
tem from the output bus connector to the input
bus connector. This will avoid an incorrect con-
nection of remote JanBus systems! Cf. chapter
„5.3 Data transfer with 800-CON module“ on
page 30.
2. If this has not yet been done, plug the bus
connector (JanBus interface) included in delivery
into the sockets on the rear of your module.
ATTENTION
Improper handling may cause damage to the
module and result in material damage!
The contacts of the bus connectors (Janbus interface)
can bend or break off and destroy the bus connector.
·
Never touch or manipulate the contacts of the
bus connector!
·
Never force the bus connector into the module!
·
When handling, transporting and storing
the module, protect the contacts of the bus
connector!
Fig.: Module rear view.
Bus connector
Bus connector
rotated
Press the bus connector
contacts into the module
sockets
pr
ess
Fig.: Module rear view
Содержание 800-CT8-A
