www.janitza.de
23
Modules 800-CT8-A | 800-CON
Fig. Example "Device and
module series": Wiring of the
transfer module (output)
Fig. Example “Remote
module series": Wiring of the
transfer module (input)
800-CON transfer
module
Shield clamp
Strain relief
800-CON transfer
module
End bracket
DIN rail
Heat-shrink tubing
Shielded
data cable
800-CT8-A
module
800-CT8-A
module
INFORMATION
The basic device does not recognize modules
during the power-up procedure!
If there is no communication to modules, the
module functions are not supported (e.g. current
measurements).
·
Disconnect your system from the power supply
and check the condition of the bus connectors
and the connections of your modules to the
basic device (JanBus interface). If necessary,
push the contacts of the module bus
connectors into the sockets of the basic device
bus connector or the attached modules so that
the bus connectors (devices) are coupled.
·
For remote module series, check the
connection of the transfer modules with the
connection via the shield clamps.
·
If necessary, restart the basic device.
·
If these measures do not lead to the desired
result, please contact our Support –
www.janitza.de
Observe the recommended data cables for the
connection between the transfer modules (see
chap. „5.4 Data cable for connecting the 800-CON
transfer modules“ on page 31)!
Содержание 800-CT8-A
