![background image](http://html1.mh-extra.com/html/jaeco/wrex/wrex_setup-instructions_3194158018.webp)
6. Using the large T-Wrench remove the two Mount
Screws with Reinforcement Washers from the MR-7
Mount Base. Insert the screws with Reinforcement
Washers through the drilled holes and into the
MR-7 Mount Base. Tighten the two Mount Screws
7. Loosen but
do not remove
the Locking Knob
on the Mount Base.
8. Position the Mount Link so that the Alignment
Pin in the Arm Mount Shaft is aligned with
the Alignment Slot of the Arm Mount Base. Insert
the shaft into the block and tighten the
Locking Knob.
9. Preposition the Mount Links so that the Mount
Shaft Base that receives the Pitch Mount Shaft is
located in the lateral 1/3 of the clients torso on
the side which you intend to use the WREX Arm.
2-11
Mount Base Attachment
Содержание WREX
