jaeco WREX, Инструкции по установке

Страница: 19 / 36

2-12
10. Snug but do not tighten the six Clamp Screws
using the Large T-Wrench. Add enough
tension so that the joints do not move easily
but can be repositioned if required to optimize
the arm alignment.
11. Hold the Pitch Mount Shaft so that the black Pitch
Pivot is at the proximal end, the hole through the
Pitch Pivot is in the line of progression of the chair
and the plate of the pivot is facing laterally. Insert
the Pitch Mount Shaft into the Mount Shaft Base.
Snug but do not tighten the screws on the Mount
Shaft Base.
12. With client sitting in the chair align the square hole
in the Pitch Pivot approximately 1 ½ inches above
their shoulder.
Note: Do not tighten the Clamp Locking Set
Screws at this time.
Note: Check to insure the Clamp Screws are accessible.
If they are not complete the steps on page 2-13.