jaeco WREX, Инструкции по установке

Страница: 29 / 36

Place the Clients Arm into the WREX
Because the WREX operates with band tension it must carefully be handled
during arm placement to prevent injury
Check for Appropriate Alignment
1. Roll Pivot joint should be 1½ inch above the
top of the shoulder to allow full shoulder range
of movement.
1. Adjust with the height of the Mount Shaft
2. Upper Humeral Pivot should be aligned with
the head of the humerus and the Lower
Humeral Pivot should align with the lateral
epicondyle.
1. Adjust by shortening or lengthening the
Humeral Elevating Links
3. Elevator Links should align with the shaft of the
humerus
1. Adjust the height of the Roll Pivot above
the shoulder
4. Clients elbow should be above the center of the
Elbow Pivot
1. Adjust depressing the bottom button on
the forearm Slide Saddle and moving the
forearm support forward or back.
4-4
1. With one hand support the WREX arm under
the Forearm Support.
2. Using your other hand lift the clients arm with
his/her elbow flexed and place it in the Forearm
Support. Insure that the back of elbow is
touching the elbow pad
3. Secure Velcro straps
Note: Insure there is clearance between the elbow area
of the Forearm Support and the Elbow Pivot,
when the clients arm is flexed.