![background image](http://html1.mh-extra.com/html/jaeco/wrex/wrex_setup-instructions_3194158014.webp)
1. Using the large T-Wrench loosen,
Do not remove,
the two T-Nut Screws on the MR-8 Mount Adapter.
2. Insert the T-Nut into Keyed Back Post channel and
position the MR-8 Mount Adapter at the marked
location (see Preparing Mount Base #1). Tighten the
two T-Nut screws.
Note:
It may be necessary to remove the Spreader Bar
(bar that links both Keyed Back Posts) to attach the
Mount Adapter below and sometimes above the
marked location. Loosen,
Do not remove,
all four
Spreader Bar bolts using 7/16 inch wrench and
slide bar out of Keyed Back Posts.
3. Orient the Arm Mount Base as shown in illustration.
Insert the Mount Base Screw (supplied with
Arm Mount Base) thru the Attachment Hole to
the MR-8 Mount Adapter. Using the large T-Wrench
secure these two parts.
Note:
If Spreader Bar was removed, reattach Spreader
bar, secure in place, and insert the plastic cap that
was removed in step 4 of Preparation instructions
Page 2-4.
Note:
Adjustments in position may be necessary for
optimal function.
4. Loosen but
do not remove
the Locking Knob
on the Arm Mount Base.
5. Position the Mount Link so that the Alignment Pin in
the Arm Mount Shaft is aligned with the Alignment
Slot of the Arm Mount Base. Insert the shaft into the
base and tighten the Locking Knob.
Mount Base Attachment
2-7
Содержание WREX
