2-34
2
A
S
SE
M
B
LY
ADVANCE 2000
• Attach the controller’s support (A) to the
cabin floor or to the tractors mudguards
in case it does not have a cabin; on trac-
tors with cabins the looms must be passed
through the points designed for said pur-
pose on the cabin. To install the controller
proceed in the following manner:
• Thread the loom from the battery (B)
through its correct point on the tractor’s
cabin leaving the connector (which will
be connected to the controller) inside it,
and the other end of the cable must be
installed on the tractor’s battery (C).
Assembling the controllers
ATTENTION!
The electrical cables and looms
were designed and manufac-
tured to be installed in the lo-
cations as described in the ins-
tructions below.
A
D
E
B
C
• The red colored cable must be connected
to the battery’s positive (+) pole and the
black cable must be connected to the bat-
tery’s negative (-) pole.
• Fasten the controller to the support and
connect the cable to it (the cable connec-
tion on the controller is done by means of
male/female connectors (D).
• Feed the loom with the female socket
through the correct point on the trac-
tor’s cabin. The female socket must be
attached together with its support to the
outside of the cabin (or to the rear of the
tractor), and the other end with a connec-
tor must be connected to the controller.
• After hitching the equipment to the trac-
tor take the male socket that is attached
to the side of the belts fairing and con-
nect it into the female socket located on
the back of the tractor.
Содержание Advance 2000 AM-18
