Jacobsen Truckster XD, Руководство по эксплуатации и техническому обслуживанию

Страница: 63 / 76

MAINTENANCE 9
en-62
9.14 HYDRAULIC FILTER _______________________________________________________
The standard hydraulic system is protected by one 10 micron filter. The filter is found on the frame rail below the driver’s
seat.
The optional high/low hydraulic system is protected by a separate 10 micron filter. The filter is found in front of the high/
low hydraulic tank.
When you replace the filters, -
a Fill the new filter with hydraulic fluid and lubricate the filter O-ring with hydraulic fluid before you assemble the
new filter. Tighten the filter with your hand.
b Operate the engine at idle speed for five minutes to remove the air from the hydraulic system. The oil-level light
can illuminate and the horn can activate during the five minutes.
c Stop the engine and check the level of hydraulic fluid in the tank. Add the hydraulic fluid to the Full mark on the
dipstick.
9.15 RADIATOR _______________________________________________________________
Check coolant level each day. The radiator and expansion
tank must be full and the recovery bottle must be at the
cold mark.
Drain and fill the cooling system each year. Empty and
clean the recovery bottle.
Mix clean water with ethylene glycol anti-freeze for the
coldest ambient temperature. Read and follow the
instructions on the anti-freeze container and the Engine
manual.
Check and tighten the engine fan belt every 100 hours and
replace the belt every 500 hours. Replace the clamps and
hoses every two years.
Have your Jacobsen Dealer check the cooling system if
you need to add coolant more than one time a month or
you add more than a quart of coolant at a time.
Keep the radiator and hydraulic oil cooler air passages clean. Use compressed air (maximum of 30 psi (2 BAR)) to
clean the fins. Move the hydraulic oil cooler to the service position to clean the radiator and oil cooler.
WARNING
To prevent injury from the hot-engine coolant or steam, never remove the expansion tank cap with the engine in
operation. Stop the engine and wait until the radiator is cool. When radiator is cool, use caution to remove the
expansion Tank cap.
CAUTION
Do not put cold water into a hot radiator. Do not operate the engine without a correct coolant mixture. Install the
radiator cap correctly.
!
!
Radiator
Expansion Tank
Recovery Bottle