Jacobsen Truckster XD, Руководство по эксплуатации и техническому обслуживанию, Страница: 42 / 76

7 OPERATION
en-41
7Operation
7.1 DAILY INSPECTION________________________________________________________
Do a visual inspection of the vehicle. Look for indications of wear or loose hardware. Look for any components that are
not included on the vehicle or damaged components. Check for fuel and oil leaks to make sure the connections are
tight. Make sure that all hoses and tubes are in good condition.
Check the fuel supply, radiator coolant level, crankcase oil level and air cleaner indicator. When the engine is cold, all
fluids must be at the full level mark.
Check the radiator and oil cooler fins for dirt or grass. Clean with compressed air as required before you operate the
vehicle.
Check all tires for the correct pressure.
Test the interlock system.
7.2 INTERLOCK SYSTEM ______________________________________________________
The Interlock System prevents the engine to start unless the clutch pedal is completely pressed. If the optional high-low
hydraulic system is installed, the high-low switch must be in the OFF position for the engine to start.
Do each of these tests to make sure the Interlock System operates correctly. If any of the tests fail, stop the test and
have the system inspected and repaired as shown below:
• The engine does not start during test 1.
• The engine does start during test 2 or test 3.
Refer to the chart below for each test and follow the check (

) marks across the chart. Turn off the engine between
each test.
TEST 1: The test shows the normal engine start procedure. The operator is in the seat, parking brake is engaged, the
optional high-low switch must be in the OFF position and the clutch pedal is completely pressed. The engine will start.
TEST 2: The engine must not start if the clutch pedal is not pressed.
TEST 3: The engine must not start if the optional high-low switch is in the LOW position or the HIGH position.
CAUTION
The inspection must be done each day when the engine is turned off and all fluids are cold. Engage the parking
brake, stop the engine and remove the ignition key.
WARNING
Do not operate the equipment with the Interlock System disconnected or the system does not operate correctly. Do
not disconnect or prevent the operation of any switch.
Test Operator Seated Clutch Pedal
completely pressed
High-Low switch in
the OFF position
Engine Starts
Yes No Yes No Yes No Yes No
1
   
2
   
3
   
!
!