9 MAINTENANCE
en-53
9Maintenance
9.1
GENERAL PRECAUTIONS __________________________________________________
A qualified technician must always do adjustments and maintenance. If the correct adjustments can not be made,
contact your Jacobsen Dealer.
Inspect the equipment according to the maintenance schedule and keep complete records.
a
Keep the equipment clean.
b
Keep all moving parts correctly adjusted and lubricated.
c
Replace worn or damaged parts before you operate the vehicle.
d
Keep all fluids at the correct level.
e
Keep the shields in position and all hardware tight.
f
Keep the tires correctly inflated.
When you make adjustments or repairs, do not wear jewelry or loose fitting clothing.
Refer to the illustrations in the Parts Manual for the removal and assembly of parts.
When you discard hazardous materials (batteries, lubricants, fuel, anti-freeze), follow your local, state or federal-
recommended procedures.
9.2
TO DO SERVICE ON THE VEHICLE ___________________________________________
Before you do service on the vehicle, empty any load in the truck bed, sprayer tank or other accessory. The truck bed
must be completely lifted and the cylinder support installed before you can service the vehicle.
To do service on the vehicle:
1.
Start the engine.
2.
Pull the lift control lever and completely lift the truck bed or
accessory.
3.
Engage the parking brake, stop the engine and remove the
key.
4.
When you service the vehicle, you must use the cylinder
support to keep the truck bed or accessory lifted. Remove
the cylinder support from the storage pin and install the
support on the cylinder rod.
5.
When the service is completed, remove the cylinder support
from the cylinder rod. Put the cylinder support on the storage
pin.
WARNING
Before you clean, adjust or repair this equipment, disengage all drives, lower accessories to the ground, engage the
parking brake, stop the engine and remove the key.
Make sure the vehicle is parked on a solid and level surface. Never work on a vehicle that is lifted only by the jack.
Always use the jack stands.
WARNING
Never do service on the vehicle without the truck bed or accessory lifted and the cylinder support installed on the
cylinder rod. When you do service on the vehicle without the cylinder supported, the bed or accessory can
accidentally lower and cause injury or death.
!
!
Cylinder
Support
Storage
Pin
Содержание Truckster XD
Страница 13: ...SPECIFICATIONS 4 en 12 C D A F G E B...
Страница 27: ...DECALS 5 en 26 Standard Left Side Control Panel Decal 4319448 Headlight Horn...
Страница 28: ...5 DECALS en 27 Diesel Speed Control Option Decal 4319448 Headlight Horn Hand Throttle Engine Governor Fast Slow...
Страница 75: ...PROBLEM SOLVING 11 en 74...