Jacobsen LF550-H-T4F, Руководство по безопасности, эксплуатации и техническому обслуживанию

Страница: 9 / 88

SAFETY 3
8
g Disconnect the battery before you service the mower. Always disconnect the negative battery cable before the
positive battery cable. Always connect the positive battery cable before the negative battery cable.
h Charge the battery in an area with good airflow. The battery can release hydrogen gas that is explosive. To
prevent an explosion, keep any device that can cause sparks or flames away from the battery.
i Disconnect the battery charger from the power supply before you connect or disconnect the battery charger to
the battery. Wear protective clothing and use insulated tools when you service the battery.
j Be careful and wear gloves when you check or service the cutting unit blades. Replace any damaged blades, do
not try to correct a damaged blade.
k Keep your hands and feet away from parts that move. Do not adjust the mower with the engine in operation,
unless the adjustment needs the engine in operation.
l Carefully release the pressure from components with stored energy.
m To prevent injury from the hot, high pressure oil, never use your hands to check for oil leaks. Use the paper or
cardboard to find leaks.
n The hydraulic fluid pressure can have enough force to enter your skin. If hydraulic fluid has entered your skin, a
doctor must remove the hydraulic fluid surgically within a few hours or gangrene can occur.
o When you service the hydraulic system, make sure the hydraulic fittings, tubes and hoses are tightened to the
correct torque. Make sure the hydraulic system is in good condition before you start the engine.
p Keep the mower and the engine clean.
q Allow the engine to become cool before storage and always remove the ignition key.
r Keep all nuts, bolts and screws tight to make sure the equipment is in safe condition.
s Replace worn or damaged parts for safety. Replace damaged or worn decals. Only use parts, accessories and
attachments approved by Jacobsen.
t To decrease the fire hazard, remove materials that burn from the engine, muffler, battery tray and fuel tank area.
u Disconnect the battery and controller connectors before you weld on this mower.
3.1.7 WHEN YOU PUT THE MOWER ON A TRAILER
a Be careful when you load or unload the mower on a trailer. Trailer must be wider than the mower and can carry
the weight of the mower.
b Use a full-width ramp to load or unload the mower on a trailer.
c Use straps, chains, cables or ropes to fasten the mower to the trailer. Both front and rear straps must be sent
down and toward sides of trailer.
d Make sure that all latches are correctly fastened.