Jacobsen LF550-H-T4F, Руководство по безопасности, эксплуатации и техническому обслуживанию

Страница: 60 / 88

9 MAINTENANCE
59
9.13 HYDRAULIC FLUID ________________________________________________________
Drain and replace the hydraulic oil if one of the following occur.
• Component failure
• Water or foam is in the hydraulic fluid
• The hydraulic fluid has a rancid odor (indication of high heat)
• Every 500 hours or each year, which is the first to occur.
Always replace the hydraulic filter when you replace the hydraulic fluid.
a Clean the area around the oil cap and drain plug to prevent dirt to enter the hydraulic system.
b Remove the drain plug from the bottom of the tank.
c After the oil has drained, install the drain plug and fill the tank with hydraulic fluid.
d Start the engine and remove the air from the hydraulic system. Operate all mower functions for 5 minutes to
remove the air and to balance the hydraulic fluid level.
e When the oil-level has balanced and the air is removed, add fluid to the tank to the Full-mark on the dipstick
9.14 HYDRAULIC FILTER _______________________________________________________
The hydraulic system is protected by two 10 micron filters. Flow through the filter is monitored while you operate the
mower. When the difference in hydraulic pressure across the filter is greater than 16 to 20 psi (1.1 to 1.4 BAR), the
hydraulic oil filter warning light on the LDU will illuminate. To make sure continued protection of the hydraulic system,
replace filter as soon as possible after light illuminates.
When you replace the filter, -
a Fill the new filter with hydraulic fluid and lubricate the filter O-ring with hydraulic fluid before you assemble the
new filter. Tighten the filter with your hand.
b Operate the engine at idle speed for five minutes to remove the air from the hydraulic system. The oil-level light
can illuminate and the horn can activate during the five minutes.
c Stop the engine and check the level of hydraulic fluid in the tank. Add the hydraulic fluid to the Full mark on the
dipstick.
9.15 TIRES ___________________________________________________________________
Keep the tires correctly inflated to increase tire life. Inspect the tread wear.
Check the tire pressure each day, while the tires are cool. Use an accurate low-pressure tire gauge.
Keep tires inflated to 12 psi (0.86 BAR).
NOTICE
During cold weather, the oil filter warning light can illuminate until the hydraulic fluid becomes warm. Wait until the
oil becomes warm and the warning light turn off before you operate the mower.
CAUTION
DO NOT try to put a tire on a rim unless you have the correct training, tools and experience. Incorrect mounting can
cause an explosion which can cause injury.
!