Jacobsen 10029194, Руководство по безопасности, эксплуатации и техническому обслуживанию

Страница: 66 / 148

B
en-66
Safety, Operation, & Maintenance Manual
MAINTENANCE
Lithium
9. Install the eleven clutch springs (P) into the brake hous -
ing (R) .
10. Assemble the pressure plate (N) into the brake housing
(R) . Align marks (F) .
11. Place brake disk and hub (L) on the pressure plate (N) .
Brake disk should be centered on the pressure plate.
12. Assemble one o-ring (M) into groove in brake housing
(R) .
13. Assemble cover plate (J) onto brake housing (R) using
two screws (K) . Alternate tightening the screws a little at
a time to compress the brake springs. Torque the screws
to 35 in. lbs. (3.9 Nm).
14. Clean the parking brake mounting area of the front axle
motor and clean the motor shaft.
15. Apply a thin film of high temperature anti-seize to the
motor shaft.
16. Assemble one o-ring (M) into groove in cover plate (J) .
17. Slide the parking brake onto the motor shaft.
18. Connect brake release harness to brake connector and
battery pack connectors. Adjust parking brake on motor
until mounting hardware (H) can be assembled.
19. Torque the three screws (H) evenly and in small incre -
ments to 53-71 in. lb. (6-8 Nm).
20. Remove brake release harness.
21. Apply dielectric grease and connect the brake electrical
connector.
22. Assemble the traction pedal sensor in reverse order of
removal.
23. Connect main power connector. Test the operation of the
brake.
P
J
K
K
L
M
M
F
N
R
F