Jacobsen 10029194, Руководство по безопасности, эксплуатации и техническому обслуживанию, Страница: 133 / 148

B
LDU ERROR CODES
en-133 Safety, Operation, & Maintenance Manual
Lithium
Signal2 Amplitude Out of Range:
The adapted amplitude is too high or
too low.
Signal1 Offset Out of Range:
The adapted offset is too high or too
low.
Signal2 Offset Out of Range:
The adapted offset is too high or too
low.
SIN COS Sensor Not Connected:
Check that the unit circle vector is
constant. The system will detect a
broken signal even if the motor is not
rotating.
Speed Error:
The speed calculated from the
sensor signals is not valid.
Negative Positive Limit:
The calculation of the positive start of
the slow down position resulted in a
negative value which is not allowed.
Positive Negative Limit:
The calculation of the negative start
of the slow down position resulted in
a positive value which is not allowed.
Dynamic Reference Ration Error:
The monitoring of the dynamic
reference ration has detected an
error. This indicates that a dynamic
reference ratio value below the
dynamic reference ratio minimum
limit has been detected when not
allowed.
Stepper Signal1 High:
The filtered stepper signal1 is above
4000mV.
Stepper Signal1 Low:
The filtered stepper signal1 is below
1000mV.
LDU Error Code Description
Caution
LED
Alarm
Sound -
ing
Engine
Stop
Traction
Stop
Mow Stop
On Off Yes No Yes No Yes No Yes No
STEERING
FAULT F0B1
STEERING
FAULT F0B2
STEERING
FAULT F0B3
STEERING
FAULT F0B4
STEERING
FAULT F0B5
STEERING
FAULT F0C0
STEERING
FAULT F0C1
STEERING
FAULT F0C2
STEERING
FAULT F0D0
STEERING
FAULT F0D1