Jacobsen 10029194, Руководство по безопасности, эксплуатации и техническому обслуживанию

Страница: 77 / 148

B
ADJUSTMENTS
en-77 Safety, Operation, & Maintenance Manual
Lithium
ADJUSTMENTS
GENERAL __________________________________________________________
• Adjustments and maintenance should always be performed by a qualified technician. If proper adjustment cannot be
made, contact an authorized Jacobsen Dealer.
• Replace, do not adjust, worn or damaged components.
• Long hair, jewelry or loose fitting clothing may get tangled in moving parts.
• Do not change speed limit settings or overspeed the drive motors.
BEDKNIFE-TO-REEL _________________________________________________
(Pre-adjustment Check)
• Check the reel bearings for end play or radial play. There should be no end play or radial play. See Torque Specifica -
tion on page 86.
• Inspect the reel blades and bedknife to insure good
sharp edges without bends or nicks.
• The leading edge of the reel blades must be sharp,
free of burrs and show no signs of rounding off.
• The bedknife and bedknife backing must be securely
tightened. The bedknife must be straight and sharp.
WARNING
Before you clean, adjust, or repair this equipment,
disengage all drives, lower implements to the
ground, turn system power off, remove key from
ignition switch, and disconnect battery pack(s) to
prevent injuries
Make sure the mower is parked on a solid and level
surface. Never work on a mower that is supported
only by the jack. Always use jack stands.
CAUTION
Be careful to prevent entrapment of the hands and
fingers between moving and fixed components of
the machine.
CAUTION
To prevent personal injury and damage to the cut -
ting edges, wear gloves and handle the reel and
bedknife with extreme care.
!
!
!
°
°
1/32”
(0.08 cm)