![background image](http://html1.mh-extra.com/html/jabiru/2200/2200_maintenance-manual_3120265056.webp)
Engine Maintenance Manual
Jabiru Aircraft
Pty Ltd
JEM0002-5
Jabiru 2200 & 3300 Aircraft Engines
This document is controlled while it remains on the Jabiru server. Once this no longer applies the document becomes uncontrolled.
ISSUE
1
2
3
4
5
Dated : 2nd June 2015
Issued By: AS
Page: 56 of 103
L:\files\Manuals_For_Products\Engine_Manuals\Engine Maintenance Manual 22 & 33\JEM0002-5.docx
WARNING
DO NOT exceed maximum propeller mount bolt torque limits provided by propeller
manufacturer.
Ensure ignitions are turned OFF before turning crank by hand.
Propeller tips are fragile: take care that they do not hit the tacking indicator or other objects
during testing.
9.3
Spinner Inspections
Required Tools:
Screwdrivers
Parts and Material:
N/A
Type of Maintenance:
Line Maintenance
Level of Certification:
L1, L2 or LAME (Owner, A&P or LSA Repairman / Maintenance)
Return to Service:
L1, L2 or LAME (Owner, A&P or LSA Repairman / Maintenance)
Checking spinner tracking is part of normal maintenance.
Locate a fixed object on a flat floor to just clear the lower edge of the tip of the Spinner.
Rotate the propeller by hand and check that the Spinner runs true.
Spinner tracking can be adjusted by loosening the mounting screws, moving the tip in the
required direction and re-tightening.
If required, spinner balance can be checked by removing the spinner and balancing it on a
sharp probe positioned inside the centre of the spinner tip. Balance can be adjusted by adding
weight as required. Contact Jabiru Aircraft or our local approved representative for details.
Note: spinner balancing is not a part of normal maintenance. It is provided for reference
purposes & for troubleshooting vibration.
9.4
Ram Air Duct Inspections
Required Tools:
Allen Key
Drill
Rivet gun
Parts and Material:
Replacement Reinforcements
Rivets (1/8”)
Type of Maintenance:
Line Maintenance
Level of Certification:
L1, L2 or LAME (Owner, A&P or LSA Repairman / Maintenance)
Return to Service:
L1, L2 or LAME (Owner, A&P or LSA Repairman / Maintenance)
Inspect ducts for damage or wear.
If the hard-points where the ducts screw to the engine are damaged they must be repaired by
the installation of reinforcement as shown in Figure 32:
While the duct is sitting on the engine position the reinforcement as shown and mark the two
rivet holes.
Drill duct to suit and rivet the reinforcement in place.