5
4. PACKING CONTENTS
1) 1 x JTECH-VW09 Video Wall Controller
2) 1 x Power Supply
(24V 2A)
3) 6 x Screws, 2 x Mounting Brackets
4) 1 x CD
(Includes User manual, RS232 Command List)
5)
1 x IR Remote Control
6)
1x USB cable
(for firmware upgrade)
5. PANEL DESCRIPTIONS
Front Panel
1
Input Status LED
: The selected source will be illuminated
2
Source
: Short press to cycle through input sources (
Type-C
→
VGA
→
DP
→
HDMI)
3
Up
: Long press to choose device setting in the OSD menu
4
Down
: Long press to choose device setting in the OSD menu
5
Menu/Left
: Long press to return to the main menu; short press to return to previous
menu
6
Enter/Right
: Short press to enter the sub-menu. If there is no sub menu, short press to
confirm the setting selection
7
Firmware Port
: Use USB cable to upgrade firmware
8
IR Sensors
: Receives IR signals from the included remote to control the device
9
Power Toggle Switch
: Turn on or turn off power
Note
:
1. Modify Output Resolution - Press & hold the "Up" and "Down" buttons together for 5 seconds
to modify the output resolution. The current input status LEDs will flash quickly and cycle through
the input status LEDs. Each input status represents a different output resolution (Type-C =
4K30Hz | VGA = 1080p | DP = 720p | HDMI = Auto). Release the “Up” and “Down” buttons
when your desired resolution’s status LED is flashing.
2. Factory Reset – Press & hold the "Menu" and "Enter" buttons together for 5 seconds. The
input status LEDs will begin to blink. After the blinking stops, the device is reset successfully.
