15
ED2 Series with Two Independent Weighing Channels
(Two position switch located on the top of the instrument housing)
The ED2-2X version of the SkidWeigh or any other models with such a feature has an additional weighing
channel that can be used to verify load weights on vehicles operating with other attachments (extension
forks, bucket, clamps or lifting container buckets, etc.) Some material handling operations require frequent
changes between the “normal forks” and other special attachments. This two channel Skidweigh is a
convenient and time saving way to continue check weighing regardless of the attachment type in usage on
the vehicle.
Calibration:
The system has a two-position switch located on top of the indicator housing
.
Mode 8
(First Weighing Channel) and
Mode 82
(Second Weighing Channel).
In
Mode 8
perform the calibration procedure as outlined previously. When finished with calibration of first
weighing channel turn vehicle power OFF/ON, and than flip the switch to the
Mode 82.
Once in the
Mode 82
perform the same calibration procedure as done previously with first weighing
channel, only this time calibrate the system with another attachment.
“Example long extension forks, bucket, etc.”
Operator Usage Procedure:
The operating procedures are the same for both channels
Note:
If the accumulative function or the onboard printer is utilized, you can switch between channels as
required. The system will automatically add the accumulative weighing loads for both weighing channels.
