ITW Simco-Ion Ion-O-Vac, Инструкция по установке и эксплуатации

Страница: 9 / 36

7
5200860 Rev H
Ion-O-Vac
Figure 2. Brush Settings for Mark IV Ion-O-Vac
NOTE : Raise or lower the vacuum heads until all brushes make a “kiss”
contact with the web material.
WEB DIRECTION
CHAD BLADE TO BE SET
1/32” TO 1/16” AWAY
FROM WEB
MICROMETER
ADJUSTMENT
Figure 3. Brush Setting for Mark I Ion-O-Vav with Chad Blades
NOTE : Raise or lower the vacuum heads until the tip of the chad blades are
about 1/16” away from the web material.
Collection System
There are five different configurations for the Canister Collection System. The
dimensions are shown in the latter part of this manual.
Find a location for your collection system. When finding a location, remember that
only 8 feet of flexible ducting is supplied with your equipment. If the collection
system is to be located beyond the 8 foot supplied, then use a rigid ducting (PVC
type) with glued seams (to avoid loss of the vacuum) avoiding elbows and sharp
bends as much as possible. Do not use more than 25 feet of at least 6” diameter
additional ducting unless the unit is specifically designed for extensive ducting.
Assemble the collection system as shown in the print. For collection systems with
sound suppressors, make sure that all the seams have been sealed with silicone
(or similar type) to prevent vacuum loss. After collection system is located and
assembled, proceed to MISCELLANEOUS ITEMS.