ITW Simco-Ion Ion-O-Vac, Инструкция по установке и эксплуатации

Страница: 11 / 36

9
5200860 Rev H
Ion-O-Vac
After the manifolds are installed (where applicable) install the 8 foot flexible ducting
to the outlet of the vacuum heads and secure in place with hose clamps. Install
the other end of the flexible ducting to the inlet of the evacuator and secure with
hose clamps. If the evacuator has been located beyond the 8 foot flexible ducting
supplied, then use a rigid ducting (PVC type) with glued seams (to avoid vacuum
loss), avoiding elbows and bends as much as possible.
Power Supply
The power supply (Model F167) is a transformer that supplies power to the static
bars and is normally shipped separately with your equipment. When positioning
the power supply, remember that the static bars are normally supplied with a 10 ft.
power cable. Locate the power supply in an area free of dirt, oil, water or excessive
heat.
Static Bars
Static bars are normally supplied with web cleaners. There are occasions when the
static bar is removed from the head to prevent damage during transit. In this case,
reinstall the static bar to the vacuum head as per installation prints. For applications
with limited space, install the static bar remotely from the vacuum head as per
installation print. Install the static bar within 1” of the material to be neutralized.
When installing, do not cover emitter points with the clamps. Route the power cable
to the power supply, making certain that the cable does not touch any grounded
metal machine parts. Use stand-off insulators provided or PVC tubing as necessary.
For wiring the static bar to the power supply, refer to Section 5. WIRING .
Compressed Air for Pneumatic Retraction Systems
For Ion-O-Vac with the Pneumatic Retraction System option, the following items
will require some assembly; 40 foot air hose, 4-way valve, and filter/regulator. A
minimum of 60 PSIG is required to operate the pneumatic retraction system. See
print number 202-0042-00 for further instructions on how to route the air hoses
and fittings. The control valve is normally located close to the operator for easy
access during webbing.
NOTE : Flow control valves are factory set and should not require any
adjustment.
Variable Speed Control
For Mark IV Ion-O-Vacs with rotary brushes, a variable speed control is supplied to
control the drive motor. This should be located close to the operator for easy access
during operation. See Figures 6 general dimensions.