13
5200860 Rev H
Ion-O-Vac
Static Bars
Before the static bars can be connected
to the power supply, the spring loaded
cable connector kit must be installed on
the cable for the static bar. See Figure 11
for installation of the connector kit to the
power cable:
1. Cut cable off at desired length, then
slide knurled plug M (knurled end
first) over cable.
2.
NOTE: MEASURE CAREFULLY,
ACCURACY IS IMPORTANT
.
3. Strip ½” insulation off end of cable.
4. Straighten copper conductor wires. DO NOT TWIST.
5. Slide high voltage connector N over conductor until it butts against cable
insulation. Be sure all strands of the conductor are inserted into the connector.
6. Slide connector body P over high voltage connector until hole in connector
body lines up with set screw hole in the connector.
7. Insert set screw Q in connector through the hole in the connector body and
tighten.
8. After tightening, if set screw is not flush with or slightly below surface of
connector body P, disassemble and remove additional strands of wire from the
conductor to allow the set screw to be at least flush with the connector body P.
9. Pull firmly to be sure voltage connector N is tight on conductor.
10. Turn contact spring R – end with close turns, clockwise, by hand, onto high
voltage connector N until spring butts against connector body.
11. If an additional contact is needed on the power supply, remove a plug or cap
from one of the other holes in the plastic receptacle. To remove plug or cap, jab
a screwdriver with an insulated handle through center and pry off. If plug or
cap has a screw slot, turn counterclockwise to remove.
12. Insert the connector into the hole and tighten the knurled plug. FINGER
TIGHT ONLY.
Variable Speed Control for Mark IV Ion-O-Vac
The installation manual for both Fincor and Bodine speed controls is shipped
with the speed controls. Please refer to the manufacturer’s manual when wiring the
variable speed control to the cylinder brush drive motor.
Figure 11. Spring Loaded Connector Installation
Содержание Simco-Ion Ion-O-Vac
