ITT Goulds Pump 3355, Инструкция по установке, эксплуатации и обслуживанию

Страница: 42 / 79

.XX
1/2 x .XX 1/2 x .XX
1
2
3
1. Sleeve bearing
2. Thrust collar
3. Coupling
Figure 15: Driver shaft centering
2. Use the instructions from the coupling manufacturer to lubricate and install the coupling.
3. Check the angular and parallel alignment of the coupling halves. See Pump-to-driver alignment in
the Installation chapter.
5.4.1 Install the coupling guard
WARNING:
• Running a pump without safety devices exposes operators to risk of serious personal in-
jury or death. Never operate a unit unless appropriate safety devices (guards, etc.) are
properly installed.
• Failure to disconnect and lock out driver power may result in serious physical injury or
death. Always disconnect and lock out power to the driver before performing any installa-
tion or maintenance tasks.
• Electrical connections must be made by certified electricians in compliance with all
international, national, state, and local rules.
• Refer to driver/coupling/gear manufacturer's installation and operation manuals
(IOM) for specific instructions and recommendations.
WARNING:
The coupling guard used in an ATEX classified environment must be properly certified and
constructed from a spark resistant material.
Required parts:
1. De-energize the motor, place the motor in a locked-out position, and place a caution tag at the start-
er that indicates the disconnect.
2. Put the pump-half of the coupling guard in place:
a) Slightly spread the bottom apart.
b) Place the coupling guard half over the pump-side end plate.
5.4 Couple the pump and driver
40 Model 3355 Installation, Operation, and Maintenance Manual