25
10.3 I
NFRARED
(IR)
L
IGHT
S
OURCE
The IR Light Source is used to supply a, high intensity, IR light, when a visible white light source is not appropriate
for video and optical illumination.
1. The IR Light Source will illuminate best if the White Balance (see Main Control Panel section 6) is in the
SET mode. While the White Balance is in the AUTO mode, view a well-lit white surface illuminated with
white light then push the switch to change to SET mode. This will lock the White Balance and prevent the
camera from trying to compensate for the IR Light.
2. Plug the fiber optic bundle into the light source before turning the power on. Turn the IR Light Intensity
Control to the minimum position by rotating the lever to the most right position.
3. Turn the IR/Blue Light Source Power Switch to the IR position. The upper green LED will turn on signaling
that the IR Light Source is on.
4. Set the light intensity to the desired level by rotating the lever left and right.
5. Turn the IR/Blue Light Source Power Switch to OFF position when not in use.
NOTICE:
The Infrared LED light source has no user replaceable parts. Contact ITI if repair is required.
Specifications
Lamp: Infra Red LED
Wave length: 880 nm peak emission
Lamp: 10-14 Volts DC, 6 Watts, 400 mA
Lamp life: more than 5000 hours
Dimming System: Manual shutter (light intensity control)
11.0
W
IRELESS
L
INK
(O
PTION
)
The V5LE Videoscope System can be configured with a video transmitter to enable the use of a remote monitor.
The remote monitor requires a remote wireless receiver operating at the same frequency (2400~2480 MHz) as
the transmitter, such as the ITI Receiver Pack shown.
11.1 T
RANSMITTER
,
V
IDEO
C
ASE
A wireless link is available to connect the V5 LE Videoscope System to a remote monitor. The transmitter is
located inside the V5 LE Videoscope System case and is controlled with the Transmitter Control Panel.
Operating Instructions:
CAUTION:
Never power up the transmitter without the antennae attached, transmitter damage will
occur.
1. With the V5 LE Videoscope System
powered up turn on the transmitter using the panel’s slider switch
labeled ON/OFF.
NOTICE: The Power indicator light should be illuminated at this time.
2. Rotate the antenna to the vertical position.
3. Set the transmitter channel selector to the same channel as the ITI Receiver Pack.