23
LED Charging Indicators:
RED LED
– indicates that the battery is charging
GREEN LED
– indicates a fully charged battery pack; also this LED will be ON when no battery is
connected to the charger.
Charging Instructions:
Disconnect the battery and remove it from the battery compartment inside the video case.
Plug the battery into the charger and plug the charger into the AC power source. The battery is expected
to charge fully in approximately 7 hours.
WARNING:
Do not use this charger with any battery pack that doesn't have a built-in protection
circuit board/module (PCB/PCM).
WARNING:
Do not use this charger to charge battery packs with less than 1.5Ah capacity. It may
cause battery explosion.
CAUTION:
Never leave batteries unattended when charging. Do not place the batteries on wooden
surface or carpet when charging.
CAUTION:
Do not recharge packs which are hot to the touch; allow them to cool down to ambient
temperature first.
CAUTION:
The charger may become hot when operating
– take care when touching the unit.
CAUTION:
Do not cover the charger, provide adequate cooling.
CAUTION:
Keep the charger, batteries, and cables away from flammable or temperature sensitive
objects.
10.0
L
IGHT
S
OURCES
The side panel of the
V5 LE Videoscope System
(see fig. 2) contains the white LED light source. The IR / Blue
light sources are located on the IR/Blue Control Panel (see fig. 3). The top light source is the IR Light Source
while the bottom is the Blue Light Source. Depending on configuration set up one or more of the sources may
be omitted.
WARNING:
The high intensity light at the front of the light sources and the tip of the
Videoscope probe will create high temperatures and bright light. To minimize the risk of injury, avoid
direct viewing or contact.
CAUTION:
To prevent injury due to bright illumination and contact with heated parts, always plug the
fiber optic bundle into the light source before turning the power on.
CAUTION:
Never cover up the light output aperture with your hands or other parts of the body (risk of
burn).
10.1 W
HITE
LED
L
IGHT
S
OURCE
The white high brightness LED light source is used to supply high quality, white light for video illumination. The
light intensity level of the white LED light source is adjustable between 0% and 100% by rotating the light intensity
control knob. The average LED lifetime is 50,000 hours (based on LED manufacturer rated wattage and thermal
operation).