ITEM 0.0.605.02, Руководство пользователя

Страница: 26 / 48

2
Important, safety information, recommendation Maintenance
General safety information
Contents
Symbols, safety
The details and information in this assembly guide are provided for the purpos-
es of describing the product and its assembly only. This information does not
discharge the user from the obligation to carry out his own assessments and
checks. It is important to bear in mind that our products are subject to a natural
process of wear and ageing. These notes contain important information that
will enable you to use the product safely and appropriately. When sold, rented
out or otherwise passed on to another party, this product must be handed over
with the assembly guide.
When assembling, operating and maintaining the KLE (compact Linear Unit), it
is important to ensure that all moving elements are secured so that they cannot
be switched on and moved unintentionally. Rotating and moving parts can
cause serious injury! You must therefore read and follow the safety instructions
set out below.
All work on and with the KLE must be performed with “safety first” in mind.
▪ Always switch off the drive assembly before you start working on the KLE.
▪ Ensure the drive unit is not switched on unintentionally, e.g. by affixing warning
notices at the activation point or by removing the fuse from the power supply.
▪ Do not place your hand within the operating range of the moving parts on the
KLE when the unit is still switched on.
▪ Fit guards and covers to the moving parts of the KLE to ensure they are not
touched unintentionally.
▪ Observe the regulations pertaining to accident prevention and environmental
protection that apply in the country and place of work where the product is
being used.
▪ Use only item products that are in perfect working order.
▪ Failure to use original spare parts will invalidate the product warranty!
▪ Check the product for obvious defects.
▪ Use the product only within the performance range described in the techni-
cal data.
▪ Ensure that all the safety equipment associated with the product is present,
properly installed and in full working order.
▪ Do not alter the position of safety equipment, circumvent it or render it
ineffective.
KLE 6 60x60 LR and KLE 8 80x80 LR, as described here, corresponds to
the state of the art and takes into account the general principles of safety ap-
plicable at the time this assembly guide was published. Nevertheless, failure to
observe the safety instructions and warning notices in this assembly guide may
result in personal injury and damage to property. We will assume no liability for
any resulting damage or injury.
We reserve the right to make technical changes that represent technical
advances. Keep this assembly guide in a place where it can be easily accessed
by all users. Observe the directions contained in the main user guide for the
completed machine. The general safety information applies to the entire lifecy-
cle of the partly completed machine.
General safety information 2
Correct use 3
Improper use 3
Selecting suitable Linear Units KLE
Design 4
Terms, geometry
5
General technical data 6
Assembly 6
Tools 7
Shaft and profile machining
7
Press-fitting the Shafts 8
Timing Belt, Strip 9
Carriage 10
Timing-Belt Reverse Unit, Timing-belt drive
12
Calculating Timing Belt tension 13
Tightening the Timing Belt 14
Support system, Carriage Plate 14
Drive, synchronisation 15
Drive 15
Synchronising two Linear Units KLE
17
Prepared KLE Drive Set 19
Proximity switches 22
Commissioning 22
Maintenance 23