DIBIPACK 3246 - 4255 STCN
Via Europa, 35 - 20010 Pogliano Milanese (MI) - Tel. 02/9396461 r.a. - Fax 02/93549494
Via del Mare 32/A (interno D) - 00040 Pomezia (Roma) - Tel. 06/9100417 - Fax 06/9100430
GB
41
TROUBLE SHOOTING
SHRINK-WRAPPING IS PERFORMED BUT
IT IS IRREGULAR AND INCOMPLETE
The film used must be the shrink-wrapping
type.
The product to be packaged is too large and
takes up the entire resting surface.
The dimensions of the product must always
be less than those of the resting surface.
THE PACKAGE IS SWOLLEN AFTER
SHRINK-WRAPPING
The film used is not micro-perforated.
Make the film pass through the micro-piercing
device of the machine
THE SEALING OPENS DURING SHRINK-
WRAPPING
Sealing blade dirty or damaged.
Rubber and/or Teflon worn out.
Clean the sealing blade; check that it is resting
correctly in its position and change if
necessary.
Sealing time incorrectly adjusted.
Adjust.
Insufficient pressure on the handle of the
hood.
Slightly increase the pressure on the handle
of the hood during sealing.
IRREGULAR SEALING
The film used has good shrink-wrapping
characteristics but bad sealing characteristics.
Replace the film.
SEALING IS NOT PERFORMED
Sealing time set too low.
Adjust according to the type of film.
The sealing wire is broken or not connected
to the clamps.
Check the clamps of the sealing wire and
make sure that the latter is not broken; replace
if interrupted.
Note: If the machine still does not function perfectly after having carried out the aforementioned checks, contact the Service Centre with an
exact description of the fault encountered.
Unsuitable or low-quality film.
PROBLEM
PROBABLE CAUSE
SOLUTION
THE HOOD IS DIFFICULT TO OPEN
The room is very cold and the oil in the gas
spring is very viscous, or the spring is partially
released.
It will return to normal after a few movements,
or when the machine is warm or – if the spring
is released – move the upper attachment to a
hole further away from the fulcrum of the
sealing frame.
THE WIRE GIVES OFF SMOKE DURING
SEALING
Sealing time too long for the type of film used.
Plastic residue on wire.
Reduce the value of the sealing time, adapting
it to the type of film used.
Clean.
The temperature value has been set too low
or the machine is not yet hot enough.
Increase the setting or wait a few more
minutes or perform a few empty cycles
THE MACHINE SEALS BUT DOES NOT
SHRINK-WRAP THE FILM
Shrink-wrapping not selected.
Check that the function has been activated.
Heating element broken.
Probe broken (interrupted).
THE SET TEMPERATURE IS NOT
REACHED
Replace.
Note: in both cases the signal light (6) will
flash after 10 minutes.
Replace.
