_________________________________________________________________________________________________________________________
PAGE 53
---
iTerra Elite
Quick Start Guide
© 2008 iSys-The Imaging Systems Group Inc.
VI. OUTPUT PROBLEMS
Jamming
For Continuous Plotting Fanfold a
JAM
could occur in 4 places.
1) Feeder
green
LED
is flashing.
•
Media is not loaded-press and hold
ADVANCE
button until green
LED
stops flashing.
2) Front of the printer while Feeder is loading.
•
Check leading edge of media for damage.
•
Check the pinch roller.
•
Check to see if media is loaded correctly through the input tray.
•
Load motor might need calibration.
3) Front of the Fuser
•
Leading edge of paper is damaged (curls or bends).
•
EXIT
Speed is too slow.
4) Behind the Fuser or past the
EXIT
of the printer.
TOP
•
Paper may not be folding properly in the Top Stacker tray.
•
Check to see if the Top Stacker is installed correctly. Check the distance to the
JAM
box.
BACK
•
Check to see if the cable is installed on the Rear Jam block.
•
Make sure paper is free to fall to the floor.
