Isokern IBV-36, Установка, эксплуатация и обслуживание

Страница: 37 / 44

FOR YOUR SAFETY READ BEFORE LIGHTING
WARNING: If you do not follow these Instructions exactly, a fire or explosion
may result causing property damage, personal injury or loss of life.
A. This appliance has a pilot which must be D. Do not use this appliance if any part has
lit by hand. When lighting the pilot been under water. Immediately call a
follow these instructions exactly. qualified service technician to inspect the
appliance and to replace any part of the
B. BEFORE LIGHTING smell all around the control system and any gas control which
appliance area for gas. Be sure to smell has been under water.
next to the floor.
WHAT TO DO IF YOU SMELL GAS
- Do not try to light any appliance
- Do not touch any electric switch;do not
use any phone in your building;
- Immediately call your gas supplier from
a neighbor’s phone. Follow the gas
supplier’s instructions.
- If you cannot reach your gas supplier,
call the fire department.
LIGHTING INSTRUCTIONS
WARNING:
Improper installation, adjustment, alteration, service or maintenance can cause injury or property damage. Refer
to manual. For assistance or additional information consult a qualifi ed installer, service agency or the gas supplier.
FOR YOUR SAFETY
Do not store or use gasoline or other fl ammable vapors or liquids in the vicinity of this or any other appliance.
1. Simply fl ip the receiver switch to the "OFF" position when manualy operated. The gas fl ow will cease, and all the fl ames (main burner
and pilot) will go out.
2. For remote operation, press the "OFF" button on the remote.
1. STOP! Read the safety information on the other
side.
2. Turn "OFF" any electrical appliance
3 . When operated with remote system fl ip the
receiver control to the "Remote" position, and
turn unit "ON" and "OFF" by using the remote
transmitter.
4.Flip the receiver switch to the "ON" position when
manualy operated. This transmits a rapid series
of sparks at the pilot head and will ignite the gas.
• Sparks cease when the pilot fl ame is lit and
stable. after a short time, the pilot will then light
the main burner.
CAUTION: IF THE BURNER DOES NOT IG-
NITE WITHIN 20 SECOUNDS, STOP WAIT 5
MINUTES, THEN REPEAT STEPS 2. THRU 4.
ABOVE.
• Normally, the pilot should remain lit. If it goes
out, repeat step 3 or 4.
• If the pilot will not stay lit after several tries, turn
the wall switch to OFF (Fig.3) and call serivce
technician or gas supplier.
• Periodically check the pilot for proper fl ame pat-
tern (Fig. 1)
100234
Fig.1
Pilot
TO TURN OFF GAS TO THE APPLIANCE
Fig.2
Fig.3
37
Safety Instructions Before Lighting & Lighting Instructions