34
Isokern Gas Burner Installation Instructions
Fig. 4 - Connect gas supply
7.
LEAK TEST: Turn on the fi replace gas supply,
and test at all connections for leaks using the
appropriate soapy water solution. If bubbles
appear, a leak is present. Turn off the gas and
tighten at all connections. Repeat until no leaks
are present. If a leak persists, turn off the gas
supply and contact the local gas company or
dealer. NEVER USE A FLAME TO CHECK FOR
LEAKS.
8.
Place the remote receiver box at the right front
corner of the fi replace. Be sure to run its wire
in between the two grate legs on the right side
of the burner system, and that the wire remains
away from the burner system and its fl ame during
operation. (See Fig. 5.)
9.
Spread the supplied lava rock on the fl oor of the
fi rebox around the front and sides of the burner
system. The lava rock may be placed around the
rear, top, and left side of the remote receiver box.
Leave the front of the box clear for control access.
DO NOT place any lava rock on the burner system,
or behind it.
10.
Proceed to the “ISO-Flames Gas Log Assembly
Instructions” section for ember and log placement.
Fig. 5 - Remote box location
Gas Log Burner Installation (cont.)
Содержание IBV-36
Страница 43: ...43 Notes...
