iMC-S8
– operating instruction
page - 25
5 Operation modes and operation
The processors operating system (firmware processor core) provides the following
operation modes:
DNC-mode:
PC/Laptop is permanent connected to the 4-axis-controller via
serial interface
Software Remote/ProNC is used to drive the controller
CNC-mode:
4-axis-controller executes user programs stand alone without a
connected PC/Laptop
Software PALPC 2.1 is used for programming and download of
user programs into the flash memory of the controller
5.1 Controller preparation
Before first startup of the controller please check the scope of delivery.
The following parts should be included:
4-axis-stepper-motor-controller iMC-S8 as desk
or 19” device
Net power supply cable 115/230VAC
RS232-communication cable,
9-pin Sub-D (female) to 9-pin Sub-D (female)
Bridging connectors
Operating instruction
If all this parts are included you can begin initial operation.
Provide all electrical connections.
Connectors
- Connect net power supply cable
- Connect axis (motors) on the controller back side
Configuration
- Set DIP-switches / jumper for motor current, step resolution, current reduction,
motor brake (see chapter 224.3.1 )
Initial operation
- Switch on controller with main power switch on the back side
- Check if emergency switch is pulled out
- Push power button on the front of the controller
Power button should be lighted green
– controller is ready for work
Operation mode
- Use the 4-axis-controller in CNC- or DNC-mode
