iMC-S8
– operating instruction
page - 26
5.2 CNC-mode
The CNC mode (automatic mode = CNC mode) is the program controlled mode of the
4-axis-stepper-motor-controller iMC-S8.
That means
that a user program which is saved in the controller’s memory (flash) will
be executed till the end.
During the automatic mode (CNC mode) you can stop the execution of the active user
program by pressing the STOP-key on front side of the controller or by using the
external Stop input. A following operation of the START-key on the front side of the
controller or the activation (1-active) of the external start input effects the resumption
of the automatic mode.
With motor cable connected axis
(linear or rotation axis) will be driven
by user program commands.
Binary inputs connected to the input port
will be
interpreted
.
Binary outputs connected to the output port
will be
set/reset
by user program.
