ipf electronic PY740025, Руководство пользователя

Страница: 7 / 67

MANUAL [ PY740025/26 ]
•
Subject to alteration! Version: 22.10.2018
ipf electronic gmbh • Kalver Straße 25 - 27 • 58515 Lüdenscheid │ Tel +49 2351 9365-0 • Fax +49 2351 9365-19 │ info@ipf.de •
www.ipf.de
7
Optional settings
FLEX MOUNT
If the sensor is mounted at an angle or the reference surface is not at the End of the measuring range Sde,
FLEX MOUNT must be activated and the reference surface taught in.
If FLEX MOUNT is activated, the following settings are reset: SCALE OUT, FIELD OF VIEW and DIGITAL
OUT.
OBJECT
Selection of bright or dark objects to optimize the measurement results.
PRECISION
To achieve better precision and resolution, it is possible to alternate between Standard, High and Very High
by filtering the output values.
SCALE OUT
Start of measuring range Sdc and end of measuring range Sde can be changed with SCALE OUT. 0V or 4mA
then apply for the start of measuring range Sdc. 10V or 20 mA apply for the point at the end of measuring
range Sde.
FIELD OF VIEW
The width of the measuring field can be changed with FIELD OF VIEW. Separate configuration of the single
points of the field: LIMIT LEFT, LIMIT RIGHT.
This function is required when there are objects in the measuring field that should not be detected.
ANALOG OUT
Start of measuring range Sdc (Offset) and end of measuring range Sde (Height) can be changed with SCALE
OUT. 0V or 4mA then apply for the start of measuring range Sdc. 10V or 20 mA apply for the point at the end
of measuring range Sde. V oltage and current output is selected under ANALOG OUT. In addition, the output
curve can be inverted under OUTP. SLOPE.
DIGITAL OUT
The sensor is equipped with a switching output that can be configured as a threshold or as a window via the
DIGITAL OUTPUT function.
Threshold: As soon as the measuring value is greater than the entered threshold, the switching output will be
changed.
Window: As soon as the measuring value is outside the entered window, the switching output will be changed.
Let's get started
The sensor continuously outputs the measuring value in mm to the display and transmits it via the analog
output to the control.
4
3b