Ioline FlexJet, Руководство по обслуживанию

Страница: 72 / 102

72 Ioline FlexJet Service Manual
Step 5: Remove the old flex cables
1. With the carriage secured, clip the plastic ties that hold the
white flex cables against the right side of the printer.
2. Pull the bundle of cables out of the grey clips (if present).
3. Pull the bundle away from the end plate if it secured with foam
tape. Lift the carriage belt tensioner out of the way if necessary.
4. From the front of the machine, pull the bundle through the hole
in the end plate.
5. Lift the cable bundle up and off the traverse moving toward the
left side of the machine. Don’t worry about the foam tape stuck
to the traverse.
Step 6: Attach the new carriage to the traverse
Important: Read these steps fully before attempting
to attach the carriage.
1. Feed the new ribbon cable bundle into the channel in the tra-
verse so that there is a loop to the left of the carriage. ( Figure
59 .) Lightly press the loop into the groove at the back of the
traverse so that it is in the cable channel.
2. Ensure that the black drive belt is between the traverse rails
and behind the carriage base. Hold the carriage at the right and
left side of the metal base with both hands and slip the top two
carriage v-wheels over the top rail of the traverse.
3. Keeping the top two carriage v-wheels on the traverse, gently
push the carriage down and rotate the bottom of the carriage
towards the back of the machine until the lower v-wheels slip
onto the lower traverse rail.
Figure 59. Make a loop in the ribbon cable to the left of the carriage.
Ribbon cable
Do not hold the carriage
by the inkjet head stalls or
the sensor.
Caution