13
13
GS62 Air Extraction System •
Installation and Operating Instructions 09/2013
INSTALLATION
2
1
5.5 Protective hood
Protective hood rear panel
Sealing tape
Holes for securing the rear panel to
the telescopic tube
Figure 7: Protective hood rear panel
1.
Apply the sealing tape (included) on the rear panel as in Figure 7. Ensure to keep a gap of approx. 7mm
on the left and right from the outer edge for sliding on the protective hood.
2.
Turn the board over. The sealing tape is facing the facade.
Protective hood cover
Sealing tape
Figure 8: Protective hood cover
3. Use the two screws (included) to attach the rear panel of the protective hood to the two
fastening elements of the telescopic tube
4. Seal the protective hood at the top edge as in Figure 8
5. Slide the protective hood*
)
onto the rear panel from above
Note:
Remove the polystyrene spacer from the telescopic tube before fitting the protective
hood
*)
Use of the GS62-Blank protective hood only after coating (by customer) with Nano Set included
1
1
2
2
3
2
1
3
