Invacare Storm 4 Series, Руководство по обслуживанию

Страница: 83 / 102

Service
Removing Headlight Holder
1. Remove rear and centre shroud. See 6.8.1 Replacing
Rear Shroud, page 55 and 6.8.2 Replacing Centre Shroud,
page 55 .
2. Take exact note of positions of all cables and sockets
that cables are connected to. Mark connectors and
sockets or take a photograph.
3. Open cable clamps (1), remove all tie wraps and pull
cable out of mobility device.
4. Disconnect cable of affected headlight from light board
(2).
Fig. 6-98
5. Loosen screw (1) and remove headlight from holder.
6. Loosen both nuts (2) and remove holder from rubber
mounting.
7. Replace holder.
Fig. 6-99
Installing Headlight Holder
1. Install parts in reverse order.
2. Install cables carefully and secure them with cable
clamps and tie wraps.
3. Tighten screws finger-tight.
4. Adjust headlight roughly using ratchet plate as a guide.
The user can carry out final adjustment following user
manual.
5. Test all functions.
6.11.9 Replacing Headlight Holder (LED on Modulite)
• 4 mm Allen wrench
• 8 mm wrench
• 6 mm Allen key
• Oblique pliers
• Tie wraps
Removing Headlight Holder
1. Remove rear and centre shroud. See 6.8.1 Replacing
Rear Shroud, page 55 and 6.8.2 Replacing Centre
Shroud, page 55 .
2. Take exact note of positions of all cables and sockets
that cables are connected to. Mark connectors and
sockets or take a photograph.
3. Open cable clamps (1), remove all tie wraps and pull
cable out of mobility device.
4. Disconnect cable of affected headlight from light board
(2).
Fig. 6-100
1533060-N 83