Invacare Storm 4 Series, Руководство по обслуживанию

Страница: 66 / 102

Invacare® Storm⁴ Series
6.9.12 Drive program selection after component replacement
The drive program is saved in the remote and in the power module. If one of these two components is replaced, the system
must be told which of the components has not been replaced so that it knows which contains the current controller profile.
The system allows normal usage of the mobility aid after component replacement only if the profile is selected
afterwards.
Profile selection with remote REM A or REM B
1. Insert the plug into the remote or into the power module respectively.
2. Switch the remote on.
3. LEDs (1) and (4) blink.
4. Use the bottom rocker switch (5) to select where the required controller profile is saved.
LED 1 = power module
LED 4 = remote
Only LED (1) or (4) blinks now depending on the selection.
5. Press the "Horn“ (2) and "+“ (3) buttons on the speed selection and hold them down for 3 seconds to confirm the
selection. The system will switch itself off and restart automatically.
In the process, the selected profile is saved in the remote and in the power module.
Profile selection with remote REM 550
1. Insert the plug into the remote or into the power module respectively.
2. Switch the remote on. The display (2) shows that you need to select a profile.
3. Use the bottom rocker switch (3) to select where the required controller profile is saved.
I = remote II = power module
The display shows which profile you have selected.
4. Press the "Horn“ (4) and "+“ (1) buttons on the speed selection and hold them down for 3 seconds to confirm the
selection. The system will switch itself off and restart automatically. In the process, the selected profile is saved
in the remote and in the power module.
6.9.13 Updating software
Invacare is continuously carrying out further development and improvements to drive programs for powered mobility
devices. For this reason, you should always check whether the drive program version number is up-to-date when carrying
out any repairs or regular maintenance.
If a new version is available, the drive program must be updated. The procedure for updating the drive program is
described in the wizard software operating manual.
66 1533060-N