Invacare Storm 4 Series, Руководство по обслуживанию

Страница: 61 / 102

Service
3.
The pictures show True Track Plus power module (1), CDI cable (2) , lighting PCB cable operating hours counter (3)
and both bus cables (4).
4. Remove cable from controls mountings (6).
5. Pull snap fasteners (3) next to True Track Plus power module (4) to rear.
6. Lift True Track Plus power module together with mounting (2) and remove mounting from battery flap (1).
7. Loosen and remove three screws (5).
8. Remove True Track Plus power modul.
9. Loosen and remove cable cover caps on motors.
10. Loosen and remove ring terminal ends on motors using 2.5 mm Allen key.
11. Replace True Track Plus power module.
Installing True Track® Plus power module
1. Install parts in reverse order.
2. Plug all plugs into their old positions.
3. Fix cable in controls mountings.
4. Push motor cable terminal ends in from side and fit. Tighten bolts with 2.5 Nm.
5. Select drive program (see “Drive program selection after component replacement”).
6. If new software version is available, update drive program. See ”Updating ”.
7. Adapt drive program using programming software if necessary.
8. Test all functions.
6.9.4 Replacing G-Trac Ssensor
• 5 mm Allen key
• 10 mm socket wrench
Removing G-Trac Sensor
1. If possible, completely raise the seat with the lifter.
2. Turn off mobility device.
3. Remove rear shroud. See 6.8.1 Replacing Rear Shroud, page 55 .
4. Take note of the positions of all cables and the sockets that they are connected to. Mark the connectors and sockets
or take a photograph with a digital camera.
5.
Fig. 6-52
6. Pull locking pin (1) backwards.
7. Lift power module up, together with bracket.
8. Remove bracket from battery box shroud.
9. Place power module, together with bracket, on top of battery box or actuator module, if installed.
1533060-N 61