Invacare Storm 4 Series, Руководство по обслуживанию

Страница: 60 / 102

Invacare® Storm⁴ Series
6.9.2 Replacing LiNX power module bracket
Removing power module
1. Remove rear shroud. See 6.8.1 Replacing Rear Shroud, page 55 .
2. Remove all plugs from power module.
3. Remove pull latch D .
4. Loosen and remove lock nut F including washer.
5. Remove power module
G
.
6. Remove power module bracket C .
Installing power module
1. Install parts in reverse order.
6.9.3 Replacing True Trac Plus power module
When replacing True Track Plus power module in connection with remote, take the final selection of drive program
into account as described in “Updating ”.
Different power modules in connection with different remotes can be fitted to mobility device. Various power modules are
described in “Power modules”. Replacement is described in following section based on example of a mobility device with
an optional lighting PCB and an optional actuator module.
CAUTION!
Any changes to drive program can affect driving characteristics and tipping stability of mobility device.
– Changes to drive program may only be carried out by trained Invacare specialist providers.
– Invacare can only give a warranty for safe mobility device driving behaviour - especially tipping stability -
for unaltered standard drive programs.
All power modules are delivered with a standard drive program. If you have made any customer-specific
modifications to drive program, these must be adapted after installation of new power module.
• 2,5 mm Allen key
• 3 mm Allen key
• Torque wrench
• To adapt drive program: programming software or hand programming device and system installation manual,
available from Invacare®.
Removing True Track Plus power module
1.
Remove rear shroud. See "Removing rear shroud”.
2. Carefully note location of cable and connection locations of various plugs. Either mark each plug and socket, or
take a photograph with a digital camera.
60 1533060-N