Invacare® Bora® / Spectra® XTR Series
3.
Remove defective locking spring. If it is not possible
to remove the defective locking spring, push the
defective locking spring (2) into the support tube using
the rod or Phillips screwdriver.
4.
Insert a new locking spring (4) into anti-tipping
mechanism up to second hole.
5.
Insert anti-tipping mechanism into support tube again
as far as it will go. To do this, press locking spring
together slightly.
6.
Make sure that locking spring latches into the holes
provided for this purpose in the support tube.
5.9 Shrouds
5.9.1 Replacing Front Shroud
•
4 mm Allen key
Fig. 5-32
1.
Loosen and remove screws
A
and corresponding
washers on front shroud
B
.
2.
Pull away front shroud.
3.
Install parts in reverse order.
5.9.2 Replacing fender
CAUTION!
Risk of crushing to hands and feet by the
weight of the mobility device
– Pay attention to hand and feet.
– Use proper lifting techniques.
CAUTION!
Risk of injury caused by uncontrolled
movement of the mobility device
– Switch power supply off (ON/OFF key)
– Engage drive.
– Before raising mobility device, secure the
wheels by blocking them with wedges.
– Prevent mobility device from tipping by
propping it up with a wooden block which
is long and wide enough under the battery
case. If the wooden block is too short or too
high, the mobility device can still tip.
Tools:
•
5 mm Allen key
•
Mounting kit
•
Wooden block (approx.12 x 12x 30 cm) for
propping up mobility device
If the fender is replaced, the existing motor bracket
screws are reused. Make sure that screws are
inserted in the correct position.
1.
Remove legrests.
2.
Release seat
A
and tilt forwards.
3.
Disconnect remote bus cable from power module or
ACT.
4.
Lift seat out of front anchorage and remove it. The
seat has a heavy weight. Use proper lifting techniques.
5.
Remove both battery boxes (see
6.
Undo and remove the four screws (1) & (2) on motor
bracket which hold the fender (4) using a 5 mm Allen
key.
7.
Remove reinforcing plate (3).
8.
Remove and replace fender.
9.
A further reinforcing plate (1) is located under the
fender.
10.
Install parts in reverse order. When reassembling,
make sure that screw (1) is shorter than screw (2).
5.10 Controls
5.10.1 Replacing Power Module
Different combinations of power modules and remotes
can be fitted to the mobility device. Power modules are
described in earlier revisions of this service manual or in
the LiNX service manual.
Replacement is described below using LiNX power module
as an example. The course of action is the same for other
power modules. The only difference is the terminal layout.
32
1528338-Q