•
Torque wrench with 19 mm socket spanner
•
Blade screwdriver
•
Mounting kit
Removing drive wheel hub
1.
Remove hub cover with screwdriver.
2.
Use 19 mm socket wrench to loosen and remove nuts
(7).
3.
Remove washer (6).
4.
Remove distance ring (5).
5.
Pull wheel hub (4) off of axle (2).
6.
Remove shim ring (3).
7.
Remove feather key (1) from axle.
Installing drive wheel hub
CAUTION!
Risk of injury if the wheels come off
If drive wheels are insufficiently attached during
assembly, they can come off during driving.
– Tighten nuts to 70 Nm when mounting drive
wheel hubs.
– Always use new nuts with undamaged
clamping parts.
1.
Install parts in reverse order.
2.
Use a thin film of lubricant to replace the wheel hub
on axle.
5.8.7 Replacing Castor Wheel on Double-Sided
Fork
•
5 mm Allen key
•
13 mm wrench
•
Oblong wooden
block (at
least 14 x 14 x 30
cm)
•
13 mm wrench
(2x)
•
Oblong wooden
block (at
least 14 x 14 x 30
cm)
•
6 mm Allen key
•
13 mm wrench
•
Oblong wooden
block (at
least 14 x 14 x 30
cm)
•
6 mm Allen key
•
13 mm wrench
•
Oblong wooden
block (at
least 14 x 14 x 30
cm)
•
5 mm Allen key
•
Oblong wooden
block (at
least 14 x 14 x 30
cm)
•
5 mm Allen key
•
13 mm wrench
•
Oblong wooden
block (at
least 14 x 14 x 30
cm)
Removing Wheel
1.
Place wooden block underneath mobility device and
prop up mobility device.
2.
Remove end-caps from bolt and nut (if applicable).
3.
Fig. 5-22
Remove nut from bolt
A
.
4.
Remove bolt and wheel from fork.
Installing Wheel
1.
Install parts in reverse order.
2.
When installing wheel, pay attention to correct
direction of rotation.
3.
Tighten nut to prescribed torque. See
1528338-Q
27