International HS 2.8L, Руководство по обслуживанию

Страница: 99 / 130

International HS 2.8L
9 8
Flywheel
Service Manual - 8120081 - 05/02
INTERNATIONAL ENGINES
FLYWHEEL
1. Remove gearbox.
2. Remove starter motor.
3. Remove clutch.
4. Install two long bolts of 8 mm in clutch bolt
holes diametrically opposites, to use as
handles when removing flywheel from
crankshaft.
5. Install tool nr. 8130638 in crankshaft pulley
and fix it with four bolts, to immobilize
crankshaft during flywheel fixation bolts
removal.
6. Loosen flywheel fixation bolts and remove it.
Note: To avoid flywheel excessive eccentricity, make sure if flywheel and crankshaft contact
surfaces are perfectly clean.
1. Install flywheel on crankshaft and fix it with
thrust plate and new bolts, tightening
according to specification.
2. Check flywheel eccentricity, assembling a
dial indicator gauge so that its point touches
at 114 mm from the center of the flywheel.
Cleaning and inspection
1. Wash all parts with biodegradable chemical
detergent.
2. Check if gear ring teeth are worn. To replace,
see GEAR RING REPLACEMENT.
3. Use a male M14 in crankshaft bolts holes, to
remove the residues of Loctite.
Reinstallation