International HS 2.8L, Руководство по обслуживанию

Страница: 22 / 130

2 1
International HS 2.8L Cooling System
8120081 - 05/02 - Service Manual
INTERNATIONAL ENGINES
COOLING SYSTEM
Circuit drainage
If it is necessary to totally drain the coolant water,
follow the instructions below:
Warning: Do not drain cooling water while
the engine is still hot and the
system pressurized.
1. Remove lower and upper radiator hoses.
2. Remove engine block drainage plug M14
(right side of the engine, front view). Make
sure that the drainage hole is not obstructed.
3. Remove radiator hoses from the engine, and
fan.
4. Drain all the coolant water from the block.
5. Check hoses condition and replace them if
they are damaged or deformed.
System filling
1. Install plug in the block and tighten it within
13 to 17 Nm.
2. Install all cooling system hoses in the inverse
order of the removal, according to the vehicle
Owner’s Manual.
3. Check in the Owner’s Manual, the level
(capacity) of the cooling system (
ra expansion reservoir - if existent).
Warning: Never check the water level
immediately after the engine
stop. This may cause burnings.