International HS 2.8L, Руководство по обслуживанию

Страница: 53 / 130

International HS 2.8L Cylinder Head
5 2
Service Manual - 8120081 - 05/02
INTERNATIONAL ENGINES
5. Install gasket with the identification holes
turned back and with “TOP” mark upwards.
6. Clean engine block contact surface.
7. Lower cylinder head on the engine block,
making sure of the correct guide-pins
position.
8. Check bolts deformation with a flat ruler,
checking their lengthening 1, diameter
reduction 2 and whether there is visible
waste in the threads 3. If one of the last 3
parameters is out of their project features,
they must be replaced.
9. Apply some lubricant oil on bolts threads and
install them in the indicated position:
10. Tighten bolts until their heads touches the
cylinder head.
11. Follow the instructions, according the table
below, to the correct application of tightening:
Positions Dimensions Torque (Nm)
1, 2, 7, 8, 9, 10, 15,
16, 17 and 18
60 Nm + 150°
3, 5, 12 and 13 M8 x 117 mm 20 Nm + 140°
M12 x 140 mm
M8 x 117 mm
4, 6, 11 and 14 M12 x 100 mm 60 Nm + 120°