International HS 2.8L, Руководство по обслуживанию

Страница: 50 / 130

International HS 2.8L Cylinder Head
4 9
8120081 - 05/02 - Service Manual
INTERNATIONAL ENGINES
12. Disconnect heating pipe from hoses and
remove it.
13. Remove wiring support fixation bolt in the
cylinder head.
14. Loosen nuts and bolts and remove rocker
arms shaft, see ROCKER ARMS - Removal.
15. Remove camshaft tappet push rods,
identifying them to reinstall in the same
position later.
16. Remove rear lift handle.
17. Uniformly loosen cylinder head fixation bolts
from engine block following the inverse of the
tightening sequence, removing them next.
18. Raise cylinder head and remove gasket.
Cylinder Head Cleaning, Inspection and
Resurfacing
1. After the complete disassembly, flush
cylinder head with chemical biodegradable
greasing remover and water at 80 °C (176 °F)
under pressure, eliminating all presence of
carbon.
Remove existent incrustations in the water
galleries. Dry with air.
2. Check for cracks or damages in the cylinder
head.
3. Check cylinder head height.
4. Check cylinder head distortion with a sheet
and a ruler of steel.