International HS 2.8L, Руководство по обслуживанию

Страница: 36 / 130

International HS 2.8L Fuel System
3 5
8120081 - 05/02 - Service Manual
INTERNATIONAL ENGINES
3. Remove special tool pin from the pump.
4. Clean pump and timing housing contact
surfaces.
5. Install pump in timing housing with a new
gasket and fix it with nuts tightening
according to specification.
6. Fix pump to timing housing with nuts,
tightening within 22 to 28 Nm, clockwise, and
finishing the tightening in the lower nut.
7. Tighten the support fixation bolts to the block
and pump bolts to the support, and tighten
within 22 to 28 Nm.
8. Connect return and fuel pipes with new
washers and fix them with banjo bolts
tightening according to specification.
9. Connect “boost control” pipe and fix it with
banjo bolt tightening it according to
specification.
10. Connect stop control solenoid wiring.
11. Connect accelerator cable.
12. Remove tool nr. 8130633.
13. Install gear lock plate.
14. Install the tool pin nr. 8130633.
15. Fix pulley with bolts.
16. Install retention plate in fuel injection pump.
17. Remove the pins of the special tools nr.
8130632 and 8130633.
18. Turn crankshaft two complete turns, check if
the pin of the tool nr. 8130633 can be totally
and easily introduced in the pump. Check at
the same time that the tool pin nr. 8130632
also can to be introduced in the hole of the
flywheel.
19. If, with the timing pin nr. 8130632 introduced
on the flywheel, the timing pin of the tool nr.
8130633 is not able to be easily introduced in
the fuel injection pump, make the timing
procedures, see TIMING.