Intermate Intermate 100, Руководство администратора

Страница: 168 / 257

Intermate100 and Intermate101 Print Server Administration Manual 168
Services in “Input Control”: ThinPrint
to use an extensions describing a printer ID, for example:
192.168.51.100:2#HP3Si
The ThinPrint server sends the value between the colon and
the # mark to the Intermate1xx. Provided that this is one of the
values listed on the table below, it will override the settings
“Output to” on the [ThinPrint] configuration page in the
Intermate1xx.
Value Where the output is sent by the print server
1 Local parallel printer port (the printer on which the Intermate1xx is attached). This printer
skips the logical layer, so there are no possibilities for pre- or post-processing, string
substitution, or functioning in a printer pool with load balancing.
1x Two-digit values starting with the digit 1 allow the user to choose a network printer without having to go
through the logical printer layer. These values only work on G32. Used on G22, they will cause the print job
to be directed to the local printer. A message will be written to the SystemLog.
11 Network Destination 1
12 Network Destination 2
13 Network Destination 3
14 Network Destination 4
2x Two-digit values starting with the digit 2 allow the user to choose a logical printer (1-8, inclusive).
21 Logical Printer 1
22 Logical Printer 2
23 Logical Printer 3
24 Logical Printer 4
25 Logical Printer 5
26 Logical Printer 6
27 Logical Printer 7
28 Logical Printer 8
all other
values The setting on the [ThinPrint] configuration page will be used.
Note that the only way to direct a job to Logical Printer 0, and thus to the System Target
Printer configured in Basic > [General], is to set “Output to” on the [ThinPrint] configuration
page to “Logical Printer 0" and avoid overruling that setting.