Interlogix TruVision TVP-5101, Руководство по настройке

Страница: 53 / 79

TruVision IP Compact PTZ Camera Configuration Manual 51
7. Set the arming schedule for the region entrance detection. The arming schedule
configuration is the same as that for motion detection. See “Motion detection
alarms” on page 39 for more information.
8. Select the actions to be used for the region entrance detection. The options are:
Notify Surveillance Center Send an exception or alarm signal to remote management software
when an event occurs.
Send Email Sends an email to a specified address when there is a motion
detection alarm.
Upload to FTP/Memory
Card/NAS Capture the image when an alarm is triggered and upload the
picture to NAS or FTP server.
Intelligent Tracking Triggers the intelligent tracking function
Trigger Recording Triggers the recording to start in the camera.
Trigger Alarm Output Trigger external alarm outputs when an event occurs. Select one of
the options: Select Trigger Alarm Output, A->1, or A->2.
Note: This option is only supported by cameras that support alarm
output.
9. Click Save to save changes.
Region exiting detection
Region exiting detection function detects people, vehicle or other objects that exit from
a designated region, and certain actions can be configured to occur when the alarm is
triggered.
To set up region existing detection:
1. From the menu toolbar, click Camera Configuration > Alarm/Event Setup> Region
Existing Detection .
2. Select Enable to enable the function.
3. Click Draw Area , and then draw a rectangle on the image as the designated region.
When you draw the rectangle, all lines should connect end-to-end to each other. Up